PRODUCT DETAILS
The Go Power! GP-ISW200-24 is a 200-watt, 24-volt industrial pure sine wave inverter for work trucks, fleet vehicles, boats and 24 V RV systems. It delivers the same clean power as a wall outlet, with a 250 W surge rating and two GFCI outlets.
Good for: Laptops, phone and camera chargers, CPAP machines without a heated humidifier and other small electronics. A Powersave mode cuts idle draw to under 0.4 A, and the output voltage is DIP-switch selectable from 100 to 120 VAC.
For a proper install, pair it with the GP-DC-KIT1 install kit (100–600 W) and an optional GP-SWR-A remote. Check that your battery bank is 24 V before ordering; the 12 V version is the GP-ISW200-12.
FEATURES
WHAT IT RUNS
SPECIFICATIONS
- Length:
- Width:
- Height:
- Weight:
| Continuous output power | 200 W (VA) |
|---|---|
| Maximum surge rating | 250 W (VA) |
| Output waveform | Pure sine wave |
| Output voltage range ± 3% | 100 – 120 VAC (DIP switch selectable) |
| Input voltage | 24 V: 20 – 32 VDC |
| Efficiency | 24 V: 91% |
| No-load current draw | 24 V: < 0.4 A |
| Low battery alarm / shutdown | 21 V / 20 V (± 0.5 V) |
| Input protection | Over/under voltage, reverse polarity (fused) |
| Output protection | Short circuit, overload, over temperature |
| AC output | Dual GFCI outlets |
| Operating temperature | -4 °F to 140 °F (-20 °C to 60 °C) |
| Cooling | Temperature and load-controlled fan |
| Dimensions (L × W × H) | 7.36 × 5.91 × 2.68 in |
| Weight | 3.5 lb |
| Install kit | GP-DC-KIT1 |
| MTBF | 130,000 hours |
| Remote (optional) | GP-SWR-A |
| Certifications | UL 458, FCC Class B |
| Warranty | 2 years |
COMPARE MODELS
MANUALS, SAFETY INFORMATION AND DOWNLOADS
FAQ
What can a 200-watt inverter run?
Anything whose running watts stay under 200 W and whose start-up surge stays under 250 W. Typical uses: laptops, phone and camera chargers, CPAP machines without a heated humidifier, small TVs.
Pure sine wave or modified sine wave?
Pure sine wave is the same clean power as a wall outlet and runs TVs, laptops, CPAPs, microwaves and chargers quietly and at full efficiency. Modified sine wave is fine for tools and lights but can buzz or damage sensitive electronics. This model is pure sine wave.
Which install kit do I need?
GP-DC-KIT1 (100–600 W), which includes the Class T fuse, fuse block and 10 ft battery cables.
How much battery current does it draw?
About 9 A from a 24 V bank at full 200 W load. Keep the inverter close to the batteries and use the cable gauge from the install kit.
Is there a 12 V version?
Yes. The GP-ISW series comes in 12 V and 24 V; this is the 24 V model, so check the input voltage of your battery bank before ordering.
What is the warranty?
Two years against defects in materials and workmanship, backed by Go Power!'s North American support team (part of Dometic).